Skip to content

Daniel Rose

← NCrunch Feature Suggestions

My feedback

3 results found

  1. Separate 'successfully completed' and 'failed tasks' in the Processing Queue window

    3 votes

    We're glad you're here

    Please sign in to leave feedback
    Signed in as (Sign out)
    Close
    Close

    We’ll send you updates on this idea

    1 comment  ·  Feature Requests  ·  Admin →
    How important is this to you?

    We're glad you're here

    Please sign in to leave feedback
    Signed in as (Sign out)
    Close
    Close
    An error occurred while saving the comment
    Daniel Rose commented  · 

    Also, in terms of clutter, it can be helpful to remove the successful tasks, but see the failed tasks. This is currently not possible.

    Daniel Rose shared this idea  · 

  2. Cleanup of workspace

    8 votes

    We're glad you're here

    Please sign in to leave feedback
    Signed in as (Sign out)
    Close
    Close

    We’ll send you updates on this idea

    0 comments  ·  Feature Requests  ·  Admin →
    How important is this to you?

    We're glad you're here

    Please sign in to leave feedback
    Signed in as (Sign out)
    Close
    Close
    Daniel Rose shared this idea  · 

  3. Pause instead of disable enable

    45 votes

    We're glad you're here

    Please sign in to leave feedback
    Signed in as (Sign out)
    Close
    Close

    We’ll send you updates on this idea

    4 comments  ·  Feature Requests  ·  Admin →
    How important is this to you?

    We're glad you're here

    Please sign in to leave feedback
    Signed in as (Sign out)
    Close
    Close
    An error occurred while saving the comment
    Daniel Rose commented  · 

    It would be nice to combine both.

    My use case: Sometimes I have some bigger refactorings or it is done on classes which cause a lot of expensive unit tests. Until I am at least somewhat done, running the unit test makes no sense. Since these are bigger changes, I save (several times) before I am done.

    Currently I handle this by switching to the "Run all tests manually" mode and then switching back.

    Daniel Rose supported this idea  · 

Feedback and Knowledge Base

(thinking…)